/* SPDX-License-Identifier: GPL-2.0-only */ /* * Copyright (C) 2018-2020 Oplus. All rights reserved. */ #ifndef TOUCHPANEL_GOODIX_OPLUS_H #define TOUCHPANEL_GOODIX_OPLUS_H #include "../goodix_common.h" #include "../goodix_tool.h" /****************************Start of define declare****************************/ #define set_reg_bit(reg, pos, val) ((reg) = ((reg) & (~(1 << (pos)))) | (!!(val) << (pos))) #define MAX_POINT_NUM 10 //max touch point number this ic support #define MAX_GT_IRQ_DATA_LENGTH 90 //irq data(points,key,checksum) size read from irq #define MAX_GESTURE_POINT_NUM 64 //max point number of black gesture #define GTP_DRIVER_SEND_CFG 1 // send config to TP while initializing (for no config built in TP's flash) //Request type define #define GTP_RQST_CONFIG 0x01 #define GTP_RQST_BAK_REF 0x02 #define GTP_RQST_RESET 0x03 #define GTP_RQST_MAIN_CLOCK 0x04 #define GTP_RQST_HOTKNOT_CODE 0x20 #define GTP_RQST_RESPONDED 0x00 #define GTP_RQST_IDLE 0xFF //command define #define GTP_CMD_SLEEP 0x05 #define GTP_CMD_GESTURE 0x08 #define GTP_CMD_CHARGER_ON 0x06 #define GTP_CMD_CHARGER_OFF 0x07 #define GTP_CMD_GESTURE_WAKEUP 0x08 #define GTP_CMD_CLEAR_CFG 0x10 #define GTP_CMD_ESD 0xAA #define GTP_CMD_HN_TRANSFER 0x22 #define GTP_CMD_HN_EXIT_SLAVE 0x28 #define GTP_CMD_ENABLE_EDGE 0X41 #define GTP_CMD_DISABLE_EDGE 0X42 #define GTP_CMD_ENTER_WATER_PROTECT 0X44 #define GTP_CMD_EXIT_WATER_PROTECT 0X45 #define GTP_CMD_ENTER_GAME_MODE 0X46 //reduce filter #define GTP_CMD_EXIT_GAME_MODE 0X47 //recover filter //gesture type fw send #define DTAP_DETECT 0xCC #define UP_VEE_DETECT 0x76 #define DOWN_VEE_DETECT 0x5e #define LEFT_VEE_DETECT 0x3e #define RIGHT_VEE_DETECT 0x63 //this gesture is C #define RIGHT_VEE_DETECT2 0x3c //this gesture is < #define CIRCLE_DETECT 0x6f #define DOUSWIP_DETECT 0x48 #define RIGHT_SLIDE_DETECT 0xAA #define LEFT_SLIDE_DETECT 0xbb #define DOWN_SLIDE_DETECT 0xAB #define UP_SLIDE_DETECT 0xBA #define M_DETECT 0x6D #define W_DETECT 0x77 /****************************End of define declare***************************/ /****************************Start of config data****************************/ #define GTP_CONFIG_MIN_LENGTH 186 #define GTP_CONFIG_MAX_LENGTH 240 //define offset in the config #define RESOLUTION_LOCATION 1 #define TRIGGER_LOCATION 6 #define MODULE_SWITCH3_LOCATION 8 //Normal config setting u8 GTP_CFG_GROUP_SAMSUNG[] = {\ 0x02,0x38,0x04,0x70,0x08,0x3A,0x3D,0x04,0xA8,0xE2,0x0E,0x6C,0x50,0x32,0x50,0x01,0x11,0x0C,0x10,0x00,\ 0x46,0x80,0x96,0xDC,0x48,0x0A,0x03,0x75,0x1E,0x3C,0x00,0x44,0x00,0x51,0x00,0x00,0x12,0x14,0x00,0x40,\ 0x3C,0x1E,0x17,0x28,0x48,0x00,0x87,0x28,0x1E,0x4D,0x4F,0xDF,0x07,0x38,0x7E,0x18,0x2D,0x54,0x24,0x44,\ 0x03,0x28,0x7D,0xC0,0x54,0xF2,0x00,0x0B,0x04,0xC8,0x36,0xA3,0x44,0x8D,0x52,0x80,0x60,0x78,0x6E,0x74,\ 0x42,0x4B,0x40,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x0F,0x1E,0x08,0x00,0x46,0xF5,0x40,\ 0x69,0x6C,0x6D,0x53,0x26,0x75,0x00,0x00,0x01,0x73,0x0A,0x32,0xFC,0x9C,0x84,0x00,0x00,0x00,0x00,0x00,\ 0x00,0x00,0x00,0x20,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x56,0xDF,0x07,0x50,0x28,\ 0x10,0x11,0x12,0x13,0x14,0x15,0x16,0x17,0x18,0x19,0x1A,0x1B,0x1C,0x1D,0x1E,0x1F,0x0F,0x0C,0x0D,0x0E,\ 0x09,0x08,0x07,0x06,0x02,0x04,0x03,0x05,0x0A,0x0B,0xFF,0xFF,0x1A,0x18,0x19,0x04,0x05,0x06,0x07,0x08,\ 0x09,0x0B,0x0F,0x0C,0x0E,0x0D,0x0A,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0x00,0x30,0x40,0x83,0x00,0x05,\ 0x04,0x0C,0x81,0x23,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x14,0x88,0x34,0x65,\ 0x78,0x00,0x14,0x50,0x6D,0x31,0x14,0x50,0x00,0x44,0x10,0x00,0x23,0x9D,0x09,0x26,0xF5,0xCF,0x01}; /*****************************End of config data*****************************/ /***************************Start of struct declare**************************/ struct fw_subsystem_info { int type; int length; u32 address; int offset; }; struct fw_info { u32 length; u16 checksum; u8 target_mask[6]; u8 target_mask_version[3]; u8 pid[6]; u8 version[3]; u8 subsystem_count; u8 chip_type; u8 reserved[6]; struct fw_subsystem_info subsystem[12]; }; struct goodix_register { uint16_t GTP_REG_FW_CHK_MAINSYS; /*mainsys reg used to check fw status*/ uint16_t GTP_REG_FW_CHK_SUBSYS; /*subsys reg used to check fw status*/ uint16_t GTP_REG_CONFIG_DATA; /*configure firmware*/ uint16_t GTP_REG_READ_COOR; /*touch state and info*/ uint16_t GTP_REG_PRODUCT_VER; /*product id & version*/ uint16_t GTP_REG_WAKEUP_GESTURE; /*gesture type*/ uint16_t GTP_REG_GESTURE_COOR; /*gesture point data*/ uint16_t GTP_REG_CMD; /*recevice cmd from host*/ uint16_t GTP_REG_RQST; /*request from ic*/ uint16_t GTP_REG_NOISE_DETECT; /*noise state*/ uint16_t GTP_REG_WATER_PROTECT_QUERY; /*water protect state*/ uint16_t GTP_REG_RAWDATA; uint16_t GTP_REG_DIFFDATA; uint16_t GTP_REG_BASEDATA; uint16_t _rRW_MISCTL__SWRST_B0_; uint16_t _bRW_MISCTL__DSP_MCU_PWR_; uint16_t _bRW_MISCTL__TMR0_EN; uint16_t _bRW_MISCTL__CACHE_EN; uint16_t _bWO_MISCTL__CPU_SWRST_PULSE; uint16_t _rRW_MISCTL__BOOT_OPT_B0_; uint16_t _bRW_MISCTL__SRAM_BANK; uint16_t _bRW_MISCTL__PATCH_AREA_EN_; }; struct config_info { char *goodix_config_ver; u8 *goodix_config; u8 goodix_int_type; u8 goodix_wakeup_level; u32 goodix_abs_x_max; u32 goodix_abs_y_max; u32 goodix_config_len; }; struct goodix_version_info { u8 product_id[5]; u32 patch_id; u32 mask_id; u8 sensor_id; u8 match_opt; }; struct chip_data_gt9286 { bool halt_status; //1: need ic reset u8 *touch_data; tp_dev tp_type; u16 *spuri_fp_touch_raw_data; struct i2c_client *client; struct goodix_version_info ver_info; struct config_info config_info; struct goodix_register reg_info; struct fw_update_info update_info; struct hw_resource *hw_res; struct goodix_proc_operations *goodix_ops; //goodix func provide for debug bool esd_check_enabled; unsigned long irq_timer; uint8_t esd_retry; }; /****************************End of struct declare***************************/ extern int gt1x_rawdiff_mode; #endif/*TOUCHPANEL_GOODIX_OPLUS_H*/